Fire Protection Services FPCL have an established range of specialist workstations to spray, mould or hand apply fire protective coatings onto critical components. Fire safety - from just a few minutes up to 4 hours - can be achieved with careful fire engineering and appropriate materials for the job in hand. FPCL have a large facility, zoned with shot blasting, drying and humidity control capabilities, and an extensive selection of moulding and spraying equipment. This allows FPCL to offer customers a range of applications, including Epoxy Intumescents, Ablatives, Fire Resistant Paints, Flame Retardants and Fire Blocking materials, all to high degrees of accuracy and quality. Test criteria are targeted at the construction industry's BS 476 range, to Defence standards, FAA and IMO. FPCL's in-house expertise, based on over 20 years of practical work, is fully geared to helping customers plan and achieve their requirements, to advise on the very best methods available and the most suitable tests required to validate them. At all times, FPCL's aim is to provide you with a friendly, helpful and informed approach so as to find the right solution to your fire protection requirements. APPROVALS AND VALIDATIONS EN BS ISO 9001:2000 EN BS ISO14001:2004 MBDA Approved Vendor status Goodrich Actuator Systems Approved Applicator of Nullifire Products to Components Lloyds Registered MOD Defence Contract No 2/87 T.U.V D.N.V CNPP BS5867 Part 2 Type B BS5852 Part 2 1982 EN 13501-1 Chilt/IF03044 Thermal Enclosure ASSOCIATIONS Coventry and Warwickshire Chamber of Commerce Association of Specialist Fire Protection SCG Railway Supply Chain Group Fire Industry Confederation (FIC) Coventry and Solihull Fire Protection Association Midlands Aerospace Alliance